Ok well its that time again. I couldnt see my build on the second page and its been 2 months since an update.
Last time I left with finding a couple of areas that needed some work still after I had blocked everything. So up first was to set these areas correct. But first here are the wet sanding pictures.
masked off for finial primer
wet sanding
roof after 400 grit
alittle shine too it
Next the annoying part. The only thing that may these pictures dont decribe is the shear amount of time this process takes. It seems to never end.
the infected area
after a skim coat and blocked again
masked off and painted, ran out to the yello high build primer so using gray now
wet sanded the area
then moved everything out and power washed the room to prep for paint
moved the other items outside for alittle work between painting
finial straighting
trying to get the latch correct
painted one with the left over primer i had mixed for the quarter
masking up for finial paint
more masking
AND PAINT! more on this later, my camera died over a couple of weeks
then masked the inside up, after about 7 hrs of scrubing and cleaning
shot the inside with Euro Gravel Guard, then ran out of that. then used GRAVITEX
again
then white on the inside
hope you guys enjoyed the update. this is still a slow go as many of you guys have personal experiences with. i landed a job in Richmond again, so its back to weekend work.
so now im back at the plastic stage redoing those areas. i hate this but hopefully its the last for the body of the car.
